Stap 1: onderdelen
1 x 10nF condensator (C6)
1 x 10 k Pot(PCB mount) (VR2)
1 x 100r weerstand (1/4W) (R5)
1 x 220r weerstand (1/4W) (R9)
1 x 330r weerstand (1/4W) (R11)
1 x 560r weerstand (1/4W) (R12)
1 x 820r weerstand (1/4W) (R13)
3 x 1K Ohm weerstand (1/4W) (R8, R10, R14)
1 x 2,2 K Ohm weerstand (1/4W) (R15)
1 x 4.7K Ohm weerstand (1/4W) (R16)
1 x 8,2 K Ohm weerstand (1/4W) (R17)
6 x 10K Ohm weerstand (1/4W) (R2, R3, R4, R6, R7, R18)
2 x 22K Ohm weerstand (1/4W) (R1, R19)
1 x 100K Ohm weerstand (1/4W) (R20)
1 x 220K Ohm weerstand (1/4W) (R21)
1 x Regulator 78L 05 (5V) (IC3)
1 x Ic houder 8Pin
1 x tuimelschakelaar (de berg van de PCB van de miniatuur) (S1)
1 x pulsdrukker (kleine tactiele) (S2)
1 x Picaxe 08M 2 (IC2)
1 x 3,5 mm aansluiting (stereo overgestapt) (SPKR)
2 x LED (rood) (LED1 LED2)
1 x accu connector(9v)
1 x vak van Project met montage schroeven (105 x 70 x 30 mm)
1 x printplaat
1 x draad Multi strand 20cm (Pad1)
1 x hitte krimpen (40mm)
1 x 9 volt batterij
U moet ook de mogelijkheid om een 8pin PicAxe program. Programmeur, programma, kabel enz.