Stap 1: materialen
Engels:
Voor dit project moet u verschillende ding:
- Plexiglas;
- Raster grafische software (zoals Gimp, pijn, Photoshop, ecc...);
- Printer;
- Gecoat karton (of plastic);
- Cutter (gebruik zorvuldig!);
- LED strip (rgb is beter);
- Attiny85 (alle Arduino boards arduino boards zal werken);
- Voeding (12v 1A maar afhankelijk);
- Draad en weerstanden;
- Schakelaar (facultatief);
- UA7805 (+ 5V regulator);
- Transistoren (ik gebruikte bd439 maar alle npn met collector-emitter-stroom > led strip huidige + 0, 5A [stroom van attiny] zal werken);
Zandstraaltoestel (denk ik het belangrijkste onderdeel van het project);
ITALIANO:
Per il progetto serviranno:
- Plexiglas;
- Software di elaborazione grafica (ad esempio Gimp, Paint, Photoshop, ecc...);
- Stampante
- Cartone plastificato (o plastica);
- Taglierino (da usare con attenzione!)
- Striscia een led (rgb è meglio);
- Attiny85 (tutte le schede arduino funzionano);
- Alimentatore (12v 1A, l'amperaggio dipende dalla striscia een led utilizzata);
- Cavi e resistenze;
- interruttore (opzionale);
- UA7805 (+ 5V regolatore);
- Transistor (io ho usato ik bd439 ma tutti ik npntransistor corrente con collettore-emettitore > corrente striscia a led + 0, 5A [corrente esagerata riferita al consumo dell'attiny] vanno bene);
- Sabbiatrice (la parte più importante del progetto);